Kategorier

More information

Triton Audio FETHead Phantom

Triton Audio FETHead Phantom

Triton Audio´s FETHead Phantom får du nytt liv i dine mikrofoner.  Hele 20dB forsterkning ved 1000 ohm gir et helt annet signal inn til forforsterkeren. En mikrofon som normalt har et svakt utgangssignal vil selvfølgelig få et bedre signal-til-støy-forhold, og mange eldre studiomikrofoner kan ha stor nytte av en aktiv forsterkerkrets plassert nærme mikrofonkilden. På mange måter er FETHead Pantom en svært rimelig oppgradering dersom du har en eldre kondensatormikrofon og en forforsterker som ikke helt gir det ønskede resultatet lydmessig.

Lagerstatus: Utsolgt

kr 920,00

Detaljer

FetHead Phantom is a FetHead version which allows phantom power to reach the microphone. It was developed after several requests from different audio engineers to build a FetHead for condenser microphones with low output. We tested FetHead Phantom on a broad range of condenser microphones and are very happy with the results. It works well with electret microphones like the countryman or an AKG C1000. These are microphones which consume little power, FetHead Phantom also works great on "real" condenser microphones like a Neumann U87, AKG C414 etc.

Philosophy

FetHead is a high quality, phantom powered in-line preamplifier providing improved sound for ribbon and dynamic microphones. The electronics are housed in a robust metal chassis with a balanced 3-pole female XLR input and a balanced 3-pole male XLR output, rugged enough for use at home, in the studio or on tour.

Which microphones benefit
In short, we noticed an improvement on all tested dynamic microphones. A Shure SM57 or SM58 for instance, sounds more responsive over a broader frequency range. When mated with a high-end dynamic microphone like a Sennheiser MD441, or Shure SM7 FetHead really shines. Ribbon microphones benefit greatly too because of a much better impedance match, which lessens the load on the microphone, giving it better transient response characteristics. FetHeads high quality, low noise signal amplification also extends the usable range of a ribbon microphone, by making it more suitable for recording softer passages without introducing noise issues.

Low noise
Fethead uses low noise jfets configured as a double class a amplifier. Jfet's are among the most quiet amplifying elements available today. The calculated noise figure of FetHead is lower than we are able to measure.

Teknisk informasjon

  • Low noise Class A JFet amplifier
  • 18db amplification
  • double single ended amplifier topology
  • input pins with phantom power
  • Balanced output
  • Lots of headroom
  • 28-48 v phantom power